Contact person: Mr. Zhao (person in charge)
Telephone (fax): 0579-85326355
Mobile phone: 15857909991
Address:Yiwu, Zhejiang Province
Zip code: 322000
三分pk拾Nowadays, as a kind of paper pipe machine, paper pipette machine is more and more widely used in the market. Here I mainly explain some preparatory work that this product needs to do after it is ready for use, so as to ensure the safety and stability of the equipment in use.
I. Ready the tape
Firstly, the raw paper that needs to be processed is cut into tapes of various specifications and widths, and then the tapes of various specified widths are placed on the paper feeding rack. In the process of subsequent equipment operation, the tapes can be exported through the paper tray and wound around the fixed mandrel through the wax roller.
2. Apply lubricating oil on the underlying paper
The subsequent bottom tape will rotate with the fixed mandrel in the direction of the outer circular cutting head, because the fixed mandrel is in a static state throughout the process, so we can reduce the friction between the tape and its rotation, and apply appropriate lubricant to the bottom tape。
Of course, there are certain restrictions on the choice of lubricants. Generally, some liquid paraffins, refined vegetable oil and silicone oil will be used. If some unsuitable lubricants are used incorrectly, it may lead to the failure of equipment to maintain normal operation in the operation process, so the choice of lubricants is very important. In addition, in the process of smearing, be sure to keep a proper amount in mind. Otherwise, if too much lubricant is applied, there will be some very slippery phenomena in the velvet, which will cause many adverse factors in the production. On the contrary, if it is applied too little, the reduction in friction will be very limited, which is quite different from what we wanted to achieve.
Therefore, the use of appropriate lubricants, as well as the appropriate amount of lubricants, is an important factor for the paper suction machine to produce high-quality products.
3. Adhesives for subsequent tapes
Of course, in addition to the first layer of paper tape need to be coated with lubricant, follow-up paper tape we need to use some binder, in this regard, we need to prepare before running the equipment, generally using some quick-drying chemical paste as the binder in the process of equipment operation, now mostly using acetic polyethylene as the binder of equipment。
IV. Electrical Connection
After some external props are ready, we can make electrical connection to the paper pipette machine. First, after three-phase power supply is connected, no-load test run of the equipment is carried out, and then the rotation direction of the equipment motor is judged, so that it must be in the right direction of rotation. By the end of idling, we can adjust the potentiometer on the controller to start the operation of the head of the equipment. V. Access to Compressed Air Pipeline
Because the paper pipette machine generally uses compressed air to cut the blade, so the inside is basically equipped with all the air pipes, we only need to connect the additional air source to the intake pipe, and then adjust the required air pressure, so that the paper pipette machine can operate normally。
Above is the paper straw machine before the operation of some preparatory work, all are provided by tall mechanical finishing, I hope you can use this product in the future, also correct preparatory work, in order to ensure the stability and reliability of the follow-up operation of the product.